Global supply of blow molding IR lamps

Mon, 13 Jul 2026 11:48:43 +0800

Getting Your Sidel SBO or Matrix lamps Right (Without the Headache)

If you’ve ever worked with blow molding lines, you know the drill. If your heat distribution is off, your PET preforms start stressing or crystallizing, and suddenly you’re staring at a pile of scrap. It’s a pain. That’s why we make our IR lamps to fit the whole Sidel lineup—everything from those old-school SBO systems to the newer Matrix series. The fit has to be perfect. Sidel machines are picky about lamp lengths and electrical loads to keep those cycle speeds where they need to be. We build our tubes to the exact millimeter. Why? Because nobody wants to spend their shift fighting with mounting brackets during a changeover. If a lamp is off by even 2mm, you’re risking a crack in the quartz glass or a loose electrical connection. It’s just not worth the risk. The nitty-gritty on heat and power We use high-wattage shortwave IR tech to get your PET up to temperature fast. These are built for high-voltage setups, which helps keep the current draw low across those long oven banks. We stick with standard R7s and SK15 connectors. They’re reliable. They handle the constant expanding and contracting of the lamp ends without shaking loose. One heads-up, though: these tubes put out some serious heat. It means your ramp-up time is fast, but it also puts a lot of pressure on your ventilation.**Keep your blowers clean.**If they’re clogged, the ambient heat builds up and your lamps won’t last nearly as long. Just swap them and go We’re all about the “drop-in” replacement. You shouldn’t have to rewire your oven or mess around with the reflectors just to switch lamps in a Matrix or SBO setup. We match the original OEM focal points so the energy hits the center of the preform right where it should. That means you don’t have to spend hours recalibrating your heating zones from scratch every time you swap a bulb. Forget the custom adapters. Just wire them up and get back to work.

Replacement lamps for all PET blow molders

Thu, 09 Jul 2026 11:21:28 +0800

Introduction

Let’s get straight to it. We make replacement lamps for PET blow molding machines, built specifically for the non-stop pace of SACMI rotary systems. These aren’t just your average heat sources. They’re precision tools, designed to keep up with the machine’s high-speed rhythm. The whole point? Delivering instant, rock-solid heat—no lag, no waiting. Just pure, steady performance that keeps your line running.

The Nitty-Gritty

SACMI machines have exacting electrical demands, and our lamps are built to meet them head-on. We dial in the 400V input to deliver the power density needed for that rapid heat-up. The 2500W rating gives you the thermal punch required to soften PET preforms in seconds, perfectly matching the molder’s cycle. And the 300mm length? It’s a precise fit, covering just the preform without wasting energy on the surrounding area. It’s a direct, drop-in replacement, engineered to match the machine’s exact footprint.

Lamps on Official IR Lamp Factory

Global supply of blow molding IR lamps

Getting Your Sidel SBO or Matrix lamps Right (Without the Headache)

Replacement lamps for all PET blow molders

Introduction

The Nitty-Gritty